S&S Cycle HP103 Easy Start Gear Drive Camshaft Kit - 330-0354

Item # : 280101

Not sure if this part fits your vehicle?

2 Check the manufacturer's website for further fitment information.

Processing Time: Leaves our warehouse in 1 to 2 days.

* Required Fields

Please enter a valid email.
Signing up...
Thanks! We will notify you by email when this item is back in stock.
  • Free Shipping on orders over $49*
  • Canada
  • Easy Returns
  • SSL Secure


  • Manufacturer: S and S Cycle


S&S Cycle HP103 Easy Start Gear Drive Camshaft Kit

  • Start any engine regardless of displacement or compression ratio with a stock starter
  • Save your starter and battery; tested for 10,000 starts without running battery down
  • Allow for easy start by initially reducing crank compression, but once the engine starts and rpm increases, the compression release lobe is centrifugally retracted and the engine runs normally, with full compression, and without any loss in performance
  • Available in chain drive and gear drive versions
  • All chain-drive cams include installation kit
  • All gear-drive cams include 4-gear set and installation kit
  • Gear-drive cams also available with inner gears only; intended for cam replacement for motors that have already been converted to an S&S gear-drive system
  • Made in the U.S.A.
  • NOTE: Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
  • NOTE: Due to the inherent characteristics of gear drives, you may experience more valve train noise.
  • Bolt in cam for 103in. and 106in. Big Bore Twin Cam motors
  • Use with stock heads (up to 10.2 compression) and low restriction intake and exhaust
  • Great for lighter bikes with strong power from 3500-6000 rpm
  • Intake Open 20 deg.
  • Intake Close 49 deg.
  • Duration (at .053) 249 deg.
  • Valve Lift .575in.
  • Exhaust 45 deg.
  • Exhaust Close 26 deg.
  • Duration (at .053) 251 deg.
  • Valve Lift .575in.

Manufacturer Part Number: 330-0354