Similar Products See other products of interest
Acerbis X-Power Engine Cover Item # 682931
Description
Features:
- Includes both ignition and clutch covers in kit
- Motor ignition / clutch covers that protect against wear from boots, impacts, dirt, mud, and other debris
- Molded openings to access the filter cover and oil cap
- Easy to install by utilizing the original crankcase and ignition / clutch cover bolts
- Resistant to high temperatures
- Designed not to interfere with boots
- Compatible with Acerbis skid plates
- Sold as a kit
Part Numbers for Acerbis X-Power Engine Cover
Fitment for Parts Acerbis X-Power Engine Cover
This part fits the following vehicles:
Reviews
Rated 5 out of
5
by
Adam from
Great fit and piece of mind
I scratch engine covers with my boots and stuff all the time. My bike isnt very wide and there isn't much to it. These covers add some piece of mind, look cool and I don't scratch my engine covers all season.
They fit nice and tight, look tough and were easy to install. They are definitely cheaper than engine covers.
Date published: 2022-10-10
Rated 5 out of
5
by
Marty from
Super bien fait
Installation très facile. Cela s’installe en 15 minutes
Date published: 2022-09-27
Rated 1 out of
5
by
Kyle from
Cracked my clutch cover installing- do not buy!
I am a stickler for correct torque for bolts on my bike. I ALWAYS check and follow my service manual for correct torque specs and have a higher end torque wrench.
This product requires that you remove certain bolts from your cover, put a spacer/ crush washer on, then re-fasten the bolts. During the re-fastening stage my clutch cover cracked. (2017 Husqvarna FE-350) there was no damage prior to this. From what felt it cracked at around 5 nm, which is pretty light. What I’m assuming happened is the crush washer crushed into the bolt hole and forced it to widen and crack.
When I saw they include a crush washer, it’s not so much a washer as a spacer. They would have done much better with a washer to spread out the load instead of point loading around the hole where the crush washer/spacer can infiltrate the hole and crack it. Which is what happened in my case.
Do not buy this, it can really easily make you lose not only $100 for a new cover, but be out the cost for this as well because I sure don’t want to buy new crush spacers to try a new install.
Date published: 2022-09-03
Rated 5 out of
5
by
R1000 from
Great fitment
Absolute must have when riding rocky technical terrain.saves casings from damage.
Date published: 2022-02-13
Rated 4 out of
5
by
None from
Good
Not bad. Should help keep scratches off the cases.
Date published: 2021-06-02
Rated 5 out of
5
by
Chuck2028 from
Protection efficace
Pour garder votre moteur avec l aspect original . C est protection sont très bien. Et sous le garde reste comme neuf
Date published: 2021-02-22
Rated 5 out of
5
by
Burn501 from
Cases are safe now.
Typical Acerbis quality. Made of strong plastic and the fit is perfect.
Date published: 2021-02-13