Similar Products See other products of interest
Cycra Rebound Handguards Racer Pack
$118.99 - $136.99
Cycra Rebound Handguards Racer Pack Item # 480564
Description
Features:
- Strongest independent mount hand guard system available
- Unrivaled strength against trail debris
- Tested for durability and quality assurance
- Great alternative to wrap around systems for woods or MX
- Patented folding shield for those unexpected quick departures
- Trick billet aluminum mounts and reinforced backbone on shield
- In-molded rubber edge provides increased protection
- Under or over bars mounting for easy installation and clean hand control area
- Include shields, mounts and hardware
- All factory colors available with decals pre-applied
- Made in the U.S.A.
Part Numbers for Cycra Rebound Handguards Racer Pack
Reviews
Rated 5 out of
5
by
KTM Ripper from
Better than expected.
Easy to fit. Tougher than I thought.
Worked great in light "through the brush trips" off the main trail (unintended excursions for a few seconds, LOL).
I laid/dropped the bike down while stopped on grave/hard pack and only the decal got damaged. I Superglue it back into place. Used Scotch bright pad to remove light scratches in the black plastic in 2 seconds.
They saved my new grips & clutch lever which did not have a mark on them from the drop. Look nice also I think. And I do not feel enclosed like I would if I had the full wrap-around tree brasher guards that mount into the end of the handlebars. I prefer to just not hit the trees.
Date published: 2018-05-30
Rated 3 out of
5
by
Vince from
meh
They look and set up ok, the theory behind them is attractive, however diggers at the track on both sides have bent/warped the brackets, will put them in the vice and attempt to bend them back straight. But apparently a good digger offers a little more torque than a broom handle. If they're not going to hold up to a solid hit, may as well spend less on a roost guard.
Date published: 2018-06-18
Rated 5 out of
5
by
ace 191 from
sturdy
fairly easy to install had to modify brackets ti clear all mounts and wires but overall tough guards so far
Date published: 2017-05-04
Rated 5 out of
5
by
Shalyn917 from
Great quality
This is my second set as I got a new bike. The first set is still holding strong after 2 years of abuse. Very impressed with the overall durability of these handguards
Date published: 2022-01-10
Rated 5 out of
5
by
Bchristi94 from
Look great and they work
After having full wrap around guards on my last bike, and after seeing Dirt Bike Channel review these, I made the switch to the Flag style handguards. These installed super easy, and they make the bike look so much better.
I only ride trails and fire roads, and these guards work perfect for the brush/trees and when my buddy’s roost me.
I’ve taken a couple small topples with these installed. They haven’t shown any scuffs and haven’t move at all. The rebound works well!
I will be throwing these on any trail bike I get
Date published: 2021-05-24
Rated 5 out of
5
by
JACQUES from
Je suis très satisfait
Je les ai achetés pour faire de la moto trial en sentier. Protègent bien les mains et comme ils sont légers ils ajoutent peu de poids au devant de la moto. Je ne voulais pas acheter des protecteurs qui sont fixes pour éviter le risque de casser les poignets que j'avais lu sur internet. Par contre, c'est cher.
Date published: 2019-08-28
Questions
Do they mount to 1â…› bars?
These handguards fit standard 7/8" bars or oversize 1-1/8" bars that taper to 7/8" at bar ends.
Date published: 2023-09-19