Similar Products See other products of interest
Kappa Engine Guard - KN1178 Item # 728596
Description
Specific engine guard, black
- 25 mm diameter steel tube
- We recommend fitting by a qualified mechanic
- Compatible with DCT and manual transmission motorcycles
Part Numbers for Kappa Engine Guard - KN1178
Fitment for Parts Kappa Engine Guard - KN1178
This part fits the following vehicles:
Reviews
Rated 5 out of
5
by
nashleigh from
Solid and look up to the job!
I got both the lower and the upper Kappa engine guards. It took me about 6 hours to install them both and line it all up - mainly because I found the instructions confusing and not very intuitive. In fairness, I'm not mechanically minded so I didn't mark them down because of that. I did have to drill out one of the mounting holes on the lower left guard to make it slightly larger (1mm) to give me enough wiggle room to line up for mounting to the frame. That was the only minor adjustment I had to make. Top guards went on great and the whole lot lined up just fine.
They feel appropriately heavy and are solid and sturdy when fitted. I haven't dropped the bike to test them but I am certain they are more than up to the task of protecting the bits that matter.
Date published: 2022-06-22
Rated 5 out of
5
by
Don from Ottawa from
Fits CRF1100 DCT
Good quality at a competitive price, straightforward installation.
Haven't drop-tested them but they seem up to the task of protecting the engine cases. Good low & wide mounting platform for LED driving lights. A little cramped for highway pegs.
One small gripe is the interference directly over the oil dipstick; it forces an odd removal angle which tends to smudge the reading. Adequate clearance for the DCT clutch filter.
Date published: 2022-05-20