Klock Werks UTV Flare Windshield

The innovative UTV Flare™ Windshield - PAT. PENDING, design features "hips" at the outer edge of the shield that re-route air, and the "flip" at the top is designed to kick the air up and back as clean, less turbulent air for driver and passenger. This means you'll have all the wind/debris protection you need without sacrificing your ability to see! Unlike flat shields that don't work if they are too low, or visibility is lost if it's too high, you'll still be able to look over the Flare™, even after it's caked in mud.

This sleek windshield is made from hard-coated polycarbonate and is available in three shades, clear, tint, and dark smoke. The kit comes with patented AXIA Alloys detach clamp hardware, roll cage clamps, and thumbscrew turn knobs, machined from billet-aluminum, then black anodized. Installation is a snap, and all necessary hardware is included. Check your fitment in the fitment section below.

Features:

• Height from hood at flip (in front of driver/passenger): 12.5", Height from hood at center: 8", Width: 40", Thickness: 0.160"
• Constructed from hard-coated polycarbonate - the same material used to creat bulletproof windows
• Provides the wind/debris protection you need without sacrificing your ability to see
• Innovative Flare™ Windshield design features "hips" at outer edge of shield that re-route air; and a "flip" at the top is designed to kick the air up and back to deliver clean, less turbulent air for driver and passenger
• Unlike flat shields that don't work if they are too low or loss of visibility if it's too high, you'll still be able to look over the Flare™, even after it's caked in mud
• Includes AXIA Alloys roll cage clamps and detachable hardware; clamps and thumbscrew turn knobs are machined from billet aluminum with a black anodized finish
• Installation hardware included

Note: To clean your shield, we would suggest using #3704-0197