Similar Products See other products of interest
Moose Pipe Armor - M-610 Item # 457356
Description
- Privateer priced pipeguard with works protection
- Sturdy armor for your vulnerable and expensive exhaust
- Helps prevent power-robbing dents
- Made in the USA
- 2 stroke only
- 3mm thick aluminum is the thickest pipe protector available
- 24in. long for universal fit on 2-stroke exhausts
Part Numbers for Moose Pipe Armor - M-610
Reviews
Rated 5 out of
5
by
Hood from
Good fit, good protection
Almost didn't buy this guard as I read many reviews saying how difficult it was to bend into shape.
I'm glad I did opt for this guard, protection seems good, and was easy to install.
I bent it into position by hand, and ended up using propane torch to lightly heat, then a rubber mallet and ball peen to shape it perfectly. A pair of 480 channellocks came in handy too.
Under 15mins to bend/install.
B.
Date published: 2020-11-18
Rated 4 out of
5
by
2strokeguy from
Bought for a FMF Fatty. Took a bit of time to bend correctly & had to use an extra hose clamp to make it work. Ended up cutting it down but seems to be working fine so far.
Date published: 2019-09-10
Rated 5 out of
5
by
Jljr from
Nice and thick
Great little guard nice and thick would have liked one more clamp size for my pipe but made the 3 that were supplied work. easy install took my pipe off the bike (cr250) attached the small end and rolled it onto the pipe rubber mallet to form the fingers aroind the bends it’s a great product
Date published: 2019-03-15
Rated 5 out of
5
by
Bernat from
Seems sturdy, good protection for exhaust
It seems a great shield to rocks when doing enduro .
I was reticent as many reviews said it’s difficult to bend. I did not use any tool, just bent by hand.
Date published: 2024-09-14
Rated 3 out of
5
by
Soag from
Seems ok, but lots of work to install it properly.
Product is OK, You definitely want a torch and a mallet to form it to fit your Pipe. Time will tell to see how Well it protects.
Date published: 2024-07-26
Rated 3 out of
5
by
ty363 from
Difficult install
Listen to the reviews when it says it’s difficult to install. The finished product is good but you’ll need a torch, hammer, vice, gear clamps and a grinder if you want a good fit.
Date published: 2022-03-28
Rated 4 out of
5
by
Amanda94 from
Great guard
The only option I had for my kx100 Mx turned woods bike, the fingers fit loose but can’t complain since there’s nothing else on the market. Also had to get a smaller hose clamp as the ones that came with didn’t go small enough on the small end of the pipe.
Date published: 2020-03-28
Rated 2 out of
5
by
Jordan from
Good quality, but difficult to bend!
I bought this pipe guard because it is tougher than other pipe guards. Ironic that for that same reason I am unable to fit it to my bike. It's not to hard to bend it lengthwise, but when you try to bend it side to side it is extremely difficult and I was unable to fit it to my bike unfortunately. The metal is just too thick on this pipe guard!
Date published: 2018-02-09