Moose Pro-Taper Contour Handguards 1 1/8in. - Black - 0635-1489
$114.95
Moose Pro-Taper Contour Handguards 1 1/8in. - Black - 0635-1489 Item # 632226
Description
Features:
- New clamps are included that feature a new angle for better cable/ hose clearance, they are longer for more lever area, no holes for added strength, and full radiuses on the edges to eliminate sharp edges
- Made from top quality 6061-T6 aluminum
- Contoured to the shape of the handlebar for better fit
- Special U-shaped inner-clamps for more cable/ control space
- More clamp sizes to more closely fit different brands of handlebars
- All mounting hardware is included
- A perfect match to the Contour Deflectors
- Sold in pairs
- Fit both dirt bikes and ATVs
- Made in the U.S.A.
Part Numbers for Moose Pro-Taper Contour Handguards 1 1/8in. - Black - 0635-1489
Reviews
Rated 5 out of
5
by
Steven from
Solid. Easy to install
I swapped my stock R1200gsa bars out for a set of Pro Tapers so I needed to change my hand guards. These worked perfect.
Date published: 2022-07-10
Rated 4 out of
5
by
Daniel E from
Perfect Fit!
I’ve had these installed for around 1000kms on a DRZ 400SM. They fit great and the install was very simple.
I bolted them into factory bar ends, they have a little bit of an angle to them from the hand guard pulled them forward but it’s still very tight and very solid.
Date published: 2022-06-13
Rated 5 out of
5
by
Animal from
Moose racing always a good product. Fits perfectly.
Date published: 2022-06-13
Questions
will this fit a 2021 BMW F750GS with a Moose Contour 2 Handguards?
Difficult to confirm. The issue is that the inboard clamps have a very specific contour which will only fit your handle bar at a very specific location. This may not necessarily line up with the inboard hole on the handguard requiring you to drill a new one at that location. This is what I had to do to make them fit my Protaper CR hi bend handlebar. Also these handguards do not dip at the outboard end unlike Barkbusters so leave your levers somewhat more exposed. Other than that, they are solid.
Date published: 2021-10-27
Are the inner mounting brackets 1 1/8” diameter? I have switched my pro-taper bar to a cfr bar and it tapers from 7/8” at the grip up to 1 1/8” at the centre. So I need to ensure the mounting brackets will fit on the thicker section of the bar.
Yes, the mounting clamps are 1 1/8" and are designed for the Pro Taper bars.
Installation tips and important info:
https://www.youtube.com/watch?v=CIDI9XVOcso
Date published: 2023-03-10