Motion Pro Crank Shaft Puller - 08-0631
$125.99
Motion Pro Crank Shaft Puller - 08-0631 Item # 600722
Description
Features:
- Precision tool used to install press-in crank shafts into an engine case
- Time saving method maintains crank shaft true during installation
- Universal steel nut adapter works on virtually all crankshafts
- 22mm and 40mm billet aluminum face plate adaptors ensure crankshaft is pulled perfectly straight into bearings
- Reversible pull stud with both M10x1.25 and M12x1.25 threads
- Eliminates the need for a shop press to install crankshaft
- Machined brass thrust washer for extra durability
Part Numbers for Motion Pro Crank Shaft Puller - 08-0631
Reviews
Rated 5 out of
5
by
Thumper from
Worked on 1966 Yamaha 305
Used to pull crank on 1966 YM1. Worked for both sides. On clutch side pulled the shaft using the stock nut till the tool bottomed out, but the crank still needed to go more. Built up the tool from the crankcase shoulder with a few 1.5 washers to finish the job. Bought a shorter bolt than the stock one to fit in the crank on the generator side (M7x50). Had to grind up some washers to fit in the adapter as the head of the bolt slipped through the hole in the adapter. Well made tool, worked well for me.
Date published: 2023-02-26
Rated 4 out of
5
by
Kelper from
Nice tool
The tool is well made but doesn't work as is with a RMZ450 on the flywheel side. I had to get to aluminum rods and use the threaded puller without the sleeve to pull in the crank. The clutch side it works perfect.
Date published: 2022-09-01
Rated 5 out of
5
by
Lime 5 from
Works perfectly
This is a terrific tool, saves a lot of fowl language, and putting parts in the freezer. Works exactly like they say it will. 10 out of 10 for me.
Date published: 2021-10-16
Rated 2 out of
5
by
Craiger from
Wonder why there is no youtube video?
The design is a massive fail for one reason, the body is round and impossible to hold without an impact, so go buy that huge socket for the top nut, that you’ll never use again.
Looks like the Tusk one is better, or get a shop to install it.
Date published: 2021-04-24
Rated 4 out of
5
by
mlatour from
well made tool, a bit $$
Purchased to install my 2010 Yamaha YZ125 crankshaft and center it in the cases. Larger M12 threaded end fits the flywheel end of the crank. A bit expensive for what it is but cheaper than damaging a crank during install.
Date published: 2019-03-26
Rated 4 out of
5
by
Yamer from
Somewhat limited
I bought this to put the crank into a '68 Triumph Trophy. It is able to do the job on one side but due to the construction of the Triumph side case I will have to jury rig something to bring the other side in as I can't get the puller close enough to the bearing. It would work fine if you can get the puller close to the bearings.
Date published: 2018-05-09
Questions
Is this crank puller universal for all cranks?
Yes, the universal steel nut adapter works on virtually all crankshafts.
Date published: 2020-03-03