Similar Products See other products of interest
Motion Pro Handlebar Mount Start/Stop Switch - Right side - 11-0098
$123.99
Motion Pro Handlebar Mount Start/Stop Switch - Right side - 11-0098 Item # 299888
Description
- Required for installation of Revolver
- Throttle Kit on bikes with ignition and starter switches in stock throttle assembly
- Fits 7/8in. bars (22.2mm)
- Extra-narrow design is only 26mm wide
- Push In/Out engine switch
- Momentary 2-pole starter switch
- Starter switch has two separate circuits, one normally open, one normally closed for street bikes that use a headlight/starter cutoff
- 550mm long wiring harness with brake light switch circuit wiring
- Brake light circuit wiring pigtail 120mm long with female spade connectors
- Stainless steel screws and internal rubber pad positions switch on handlebar securely without drilling holes
- Wiring harness has bare, tinned wires without connector for easy installation of OE connector body
- Made in Italy by Domino
Part Numbers for Motion Pro Handlebar Mount Start/Stop Switch - Right side - 11-0098
Reviews
Rated 5 out of
5
by
Glenn from
Surpasssed my expectations
This is a quality made switch gear, the construction is very solid.
What I like about it...
- internal wiring is well put together
- mounts solidly to the bar
- instruction were very helpful
- size and fir are perfect for my application
Date published: 2021-04-19
Questions
Is the engine switch normally open or closed in the run position?
Not sure I have not looked at the circuit. But it is a direct replacement for the kill switch. Meaning that the on position do the same thing as the kill switch on the run position. Not a direct answer to your question but I hope it helps.
Date published: 2018-07-13