Olympia CE Back Protector Item # 647781
Description
Made from the very best German made polymer, the Olympia armour is sturdy enough to offer CE Level 2 protection, but it is flexible enough to stay comfortable at all time.
The Olympia Back Armour is perforated to allow proper venting of the jacket without compromising on protection.
Features:
- 375mm x 295mm (14 3/4" x 11 5/8")
Designed for optimal fit in the back pocket of the following Olympia jackets:
- Olympia Dallas Jackets
- Olympia Newport Jackets
- Olympia Eve Jackets
- Olympia Bradley Jackets
- Olympia Hudson Jackets
- Olympia Troy Jackets
- Olympia Kanto Jackets
- Olympia Vincent Jackets
- Olympia Bishop Jackets
- Olympia Janis Jackets
Part Numbers for Olympia CE Back Protector
Reviews
Rated 5 out of
5
by
Twoscoops from
Great replacement!
Direct replacement - drops right in. Broke my back protector when folding my Olympia jacket to put it in the side case. This is a direct replacement and identical to the original that came with the jacket.
Date published: 2024-12-20
Rated 4 out of
5
by
GM84 from
Good Value Despite Poor Quality Control
The photo shown above depicts completely open vent holes, however there must not be much of a QC inspection. The one I received was essentially ventless, with a thin layer of foam covering almost every hole. Maybe 5% of the holes let a pin prick of light through. This only took a few minutes with a small drill bit to finish the holes, so still a good product for the cost, if slightly annoying.
Date published: 2023-06-01
Rated 5 out of
5
by
Kevmetal25 from
Super léger!!
Vraiment une super dorsale, légère, c'est maintenant une de mes dorsales préféré. j'en utilise 3 autres et c'est dans mon top 2. Rien à redire, en plus d'être de niveau 2, soit la meilleur protection.
Date published: 2022-10-19
Rated 5 out of
5
by
Steph from
Très bien!
Ils sont de bonne qualité, ils font bien dans mon modèle de manteau, ils semblent assez universels!
Date published: 2021-11-27
Rated 5 out of
5
by
SkullBeard from
Excellent upgrade
I bought this to replace the armour that came with my Open Road touring jacket.
Soft and supple as opposed to the rigid, two layer foam armour that the jacket.
Dropped right in and fit like a glove.
Date published: 2021-03-01
Rated 5 out of
5
by
Snyd from
Fits perfect, value priced
I had an Existing merlin jacket that had a stock bath protector in it that was not CE approved. It’s back protector fit perfectly into the pocket and it’s a much better product
Date published: 2021-02-15
Rated 4 out of
5
by
Rickd4004 from
This fit into my ICON Merc Jacket
I bought this along with the elbow and shoulder armour to replace the deteriorating original jacket armour. This back protector was a real upgrade as the original was just a piece of foam rubber. It was slightly wider thru the midsection than the original and I thought I might have to trim it, but with a little work and manipulation I managed to get it into the pocket of the liner. Very soft and comfortable.
Date published: 2019-07-11
Questions
What are the dimensions of this back protector?
375mm x 295mm (14 3/4" x 11 5/8")
Date published: 2019-05-31