Pivot Works Fork Seal Kit Item # 223780
Description
- One kit does both fork legs
- Oil seal and dust wiper set
Part Numbers for Pivot Works Fork Seal Kit
Fitment for Parts Pivot Works Fork Seal Kit
This part fits the following vehicles:
Reviews
Rated 5 out of
5
by
teej from
fit well
Great product works well and comes with dust seals
Date published: 2022-02-08
Rated 4 out of
5
by
Warren from
Good product
I purchased these because the local dealer was not even selling OEM and it was a two week wait. These was about half the price of me purchasing OEM on line. Delivery was fast as usual and they worked as they should. The only thing I would recommend is like OEM, the kits should come with the copper washers and clips. My existing ones worked but if they would have leaked it would have been quite frustrating and a major headache to have to redo it.
Date published: 2022-08-23
Rated 5 out of
5
by
Dsnuts from
Worked great no leaks. Easy to apply seals. Not super tight so they will not damage on installing.
Date published: 2021-06-20
Rated 5 out of
5
by
VersyMcVerseFace from
Solid replacement seals
Had to replace my seals after my suspension started leaking oil all over my beautiful brakes. It was about time, my OEM seals had lasted 10 years up to that point. Anyway, MikeyMoto in Etobicoke did an amazing job rebuilding my suspension, and they're leak-free for about 2 months now. Good seals!
Date published: 2021-05-22
Rated 5 out of
5
by
Gauvin3306 from
Amazing pars
Bought installed they were a nice tight fit and are holding up great!!
Date published: 2017-10-27
Rated 4 out of
5
by
radio rowat from
No Washer
I wish these came with it came with the soft steel washer - it was deformed when we removed the old seals. you have to hammer it flat - that was the trick. didn't have the special install tool slider hammer, so i made with PVC pipe cut in half. used the bottom part of the fork as the hammer; worked well in the end.
Date published: 2015-11-03
Rated 1 out of
5
by
Dad2u from
This seal kit was a failure
I bought this to rebuild a leaking fork on my KTM500EXC. The oil seal in this kit was nearly 1mm higher than the stock, and no amount of pounding would seat it far enough to allow the circlip to be installed. I finally trimmed the rubber edge down enough to force the circlip in its grove. The oil seal began leaking within days. I rebuild with a kit from SKF: what a difference, installed cleanly and easily, and no leaks.
Date published: 2022-09-04
Rated 5 out of
5
by
Aaron Cyman from
Great product.
Easy install! Worked nice and sealed well. Used on a YZ250F
Date published: 2025-10-20