Wolf Tooth Boostinator Hub

Boostinator kits allow non-boost wheels to be mounted in Boost spacing frames and forks.

The kits consist of a specially-designed axle end cap and—in the case of rear kits—a precision-machined rotor spacer with a set of six high-strength bolts. In keeping with Boost specifications, the disc and cassette are shifted outboard, allowing brakes and derailleurs to function as designed.

Features:

• Boostinator converts regular spacing wheels (15x100 mm, 12x142 mm) to Boost spacing (15x110 mm, 12x148 mm), so you can keep your good old wheels on your new Boost frame!
• Rear kits include a left-hand axle end cap, a rotor spacer and longer rotor hardware
• Wheels will need to be re-dished after installing the Boostinator
• Please note that using the Boostinator may void the warranty of the wheel or hub
• Rear DT kit fits all hubs with DT internals, but is not compatible with Center Lock hubs

Compatibility:

• Specific model compatibility listed below under the "Models" section
• Front boostinators are only an endcap and do not require rotor spacer. The wheel is re-dished
• Rear boostinators require both a re-dish and rotor spacer
• Rear Boostinator kits are not approved for rotors larger than 183 mm
• Hubs spacing is 100 mm front and 142 rear, and the Boostinators make them 110 and 148 respectively
• Compatible with 6-bolt FRONT wheels and SOME centerlock models
• Compatible with ONLY 6-bolt REAR wheels (there is no way to space centerlock rotors over 6 mm)

Specifications:

Boostinator DF2

• TheBoostinatorDF2 is compatible with DT-Swiss 2011 and newer 15x100 mm 240s front hubs
• Use DF-20 for 240s Oversize (20 mm convertible) hubs. These hubs have a threaded non-disc side endcap that has little wrench flats on it
• Centerlock hubs are supported
• The Boostinator DF2 is also compatible with some complete DT Swiss Spline One front wheels. Click here for a compatibility table
• Net weight: 6 g

Boostinator DF3

• The Boostinator DF3 is compatible with DT-Swiss 15x100 mm 350- and 370-series front hubs
• Centerlock hubs are supported
• The Boostinator DF3 is also compatible with some complete wheels from DT Swiss. Click here for a compatibility table
• Net weight: 5 g

Boostinator DF20

• The Boostinator DF2O is compatible with DT-Swiss 15x100 mm 240s Oversize (20 mm convertible) front hubs. These hubs have a threaded non-disc side endcap that has little wrench flats on it
• Net weight: 5 g

Boostinator DR

• The Boostinator DR is compatible with DT-Swiss 12x142 mm Star Ratchet (240- and 350-series) rear hubs with 6-bolt (IS) rotor mounts
• Centerlock hubs are not supported
• 180- and 190-series hubs are Centerlock only
• The Boostinator DR is also compatible with some complete wheels from DT Swiss, Roval (Specialized), Giant, Syncros (Scott), and others that use DT's Star Ratchet internals. A compatibility table of DT Swiss wheelsets is available here
• Remove the disc side end cap. Bearing size 6802 15x24
• Net weight: 18 g

Note: You will need to re-dish your wheel after installing any Boosinator. NOT recommended (or safe) for non-symmetric lacing like the 2:1 lacing found on some of Industry Nine's wheels.